I have had a few LRP sphere speed controls and I have recently purchased one used and the problem in I can't get it into setup mode. I've tried do the setup prcedure using different batteries, recievers, motors with sensor pluggen in and unplugged...The Speedcontrol does work it just wont go into setup mode.

1. Radio on

2. turn on speedcontrol

3. press and hold the set button until the set button blinks (this is where the issue is nothing happens)

I googled the problem and I found a few other had the same issue. Someone did say to clean the set and mode buttons with motor spay. I did that still same thing.

Please help...