Originally Posted by
Owen RaCing
Ronald,
what procedures do you take to prepare your car for a run/ between runs? Also, what tools and techniques do you use for set-up (Set-up station, camber gauge, droop over ride..)
Originally Posted by
R.Völker
nothing special, i'm using only a normal camber gauge and droop gauge by yokomo, ride height tool by xenon and no station at all
interesting, but I suppose if you don't crash, then the setup station is not required.
Can you tell me your procedure when building a new car?
eg. like.....do you use a tweak station, corner weights, left/right balancing....