half way through my build.

what I have noticed so far;

not too happy with the spur arrangement, this is new to me.

not happy with the motor mount being raised a couple of mm off chassis,even though it has the motor brace for support. This is new to me too

cvd's bind when using grubs screws, so I didn't put the grub screws on, I gather with the sleeve, the pins not falling out anyway. I dont understand as the grub screw head is not touching anything to make it bind.

chassis was tweak free before build, now half way through have noticed a tweak. Has anyone else noticed this? I criss crossed the screw pattern for top deck tightening, but even with the screws loose, there is a tweak!!! All the coutersink screws seem deep enough into the chassis, so its not the screws protruding thats making the chassis warp. I dont understand what to do next to get rid of it. Is there a way to tweak free a chassis by yourself? just dont have an extra hand laying around

AE must of went through all the bulkheads, as I can see a freshly tapped hole, which was done AFTER anodizing. At least the newer kits will be all good.

Missing the steering bellcrank C-clip, no big deal, just need to order from amain but thats an extra 2 weeks wait as I'm outside the US and know that my LHS will not have that part.