Why are there so many emotionally delicate people the RC world? Shessh!!!
Originally Posted by
Manshoon
I should of been a little more specific, there is a spacer between the center diff and the chassis, this is where my problem was lining everything up to mount the Castle/Grid/Diff to the 4 chassis screws with one hand.
If you had read my signature you would see I am running the Castle Creations 2200Kv motor and not the Tekin, the mounting holes are different and two of my mounting screws are behind the Spur gear. After taking the center plate out of the Grid mount I still couldn't get the right angle for the wires off the 2200KV motor, to allow enough room to rotate the center plate in the Grid Mount to allow for pinion mesh.
Hence the whole separation thing. But before you decide to comment on my attention span and reading comprehension again, at least semi know the facts and then be sure to have read your own.
Tekin or Castle, it doesn't matter. The instructions show the holes for both.
1. People run with the GRID mount
without the center diff spacer. It's not needed. Just another one of the +'s to running with a GRID.
2.
After taking the center plate out of the Grid mount I still couldn't get the right angle for the wires off the 2200KV motor, to allow enough room to rotate the center plate in the Grid Mount to allow for pinion mesh
I'm sorry, I just do not understand. Are you talking about the plate for the diff, not the mount? I'm not sure what you're talking about with the "Grid center plate". But I think I know what you're talking about with the wires...
You can actually secure the GRID motor plate to the mirror side of the motor plate. This will allow you to rotate the plate to mesh the pinion to the spur. If you look closely, the GRID plate should be a little bit off center. You can change that to it's reciprical side.
In the instructions as well
Don't fret man... I put my ESC fan on top of the whole thing! I even installed my rear diff. backwards! My shock cup was on reversed. We all miss stuff in the directions... don't take offense.
Originally Posted by
slash_me_up
Yes Yes Yes we have had this discussion before!!! Thanx for your not needed opinion IMO!!!
Feelings hurt alert!
