R/C Tech Forums - View Single Post - Rc10ntc3
Thread: Rc10ntc3
View Single Post
Old 03-20-2002, 10:08 PM
  #372  
Motorman
Tech Master
iTrader: (1)
 
Motorman's Avatar
 
Join Date: Nov 2001
Location: Michigan
Posts: 1,911
Trader Rating: 1 (100%+)
Default

OB
X Rays rock dude
Look The NTC3 is pushing it OK. The MTX might still give it a slap job. least you finally parked that NO BEE and got a race car. LOL DOH! Damn snow, was this your Idea!! WTF Going to FT Myers and then having to park the toys for another 2 months really has me Jacked. I'm like the mad scientist right now, wife won't even come into the shop, she just slides dinner under the door.

SX EV1 I'll check, I dont think so but don't quote me till I rustle through some notes.

Ya man need Centax, HUM custom bell, I know I got a machinist with a Hardinge just sitting around at the moment. Sounds like a G Job. Nope 10th serpent cap wont fit right, did that first, pivot holes no line up :{ Not even close.

Proud winner, Its probably to rich but trust me if its rifling fule out the vent into the pipe when you lift off the throttle it surely aint helping
Motorman is offline