View Single Post
Old 03-27-2011, 09:57 PM   #2
inferno13
Suspended
 
Join Date: Dec 2009
Location: northern michigan
Posts: 7,916
Trader Rating: 202 (96%+)
Default

Quote:
Originally Posted by thekisscutken1 View Post
hey guys i know there is something wrong with my servo saver and would like to know how everyone does it. i've broken a few metal gear servos in the couple weeks i've had this used truggy. is there any way to feel if it is working ok? is there an easy way to tighten/loosen the nut? any help in setting this thing up will help very much.

ps: i notice my front wheels shaking side to side a lot under hard acceleration out of a turn. does a poorly setup servo saver have anything to do with it?
it could, i use the aluminum upper peice on the servo saver, what servos are you useing? many things could cause wheels to shack all over, play in turnbuckle ends, servo saver, tires out of balance, broken or cracked wheel, i normally tighten the servo saver up more than i should. if you have a manual there are some tips, if not down load it and have a good read, there are many good tips on how to set up
__________________
D8 "HARA", OS SPEED, ,SAVOX 1267/68 SERVOS, BYRONS 25%, SPEKTRUM DX3R PRO
D8T GO GXII ,SAVOX 1267/68 SERVOS, BYRONS 25%, SPEKTRUM DX3R PRO
NMRCC -(northern michigan rc club)
inferno13 is offline   Reply With Quote