Originally Posted by IndyRC_Racer

I have a setup question.

I'm running an M03-L on high bite ozite.
- Yellow front springs 80 wt oil
- Red rear springs 80 wt oil.
- 60d tires front/rear
- Tamiya hard foam inserts
- Tamiya A or Tamiya S fronts
- Tamiya S rears.
- A-arms front/rear are almost level (have a little down travel when off the ground)
- Cooper S body
- Silvercan

The problem I'm having is that on very high bite corners, the car wants to traction roll. I'm wondering if I'm missing something obvious on the setup. I though about going to blue springs in the front, but thought that might increase the traction roll and take away steering.

Any advice from high bite ozite Mini racers?