Originally Posted by Still Bill

If you have any version of a Gen-X 10 you should only need the #1766 - Rear Bottom Plate (with the added mounting hole) and the #3351 - Micro Left Pod Plate to make the update.

However, I think the Micro Left Pod Plate is better suited to the 1/12th scale XL car. On the heavier Gen-X 10, it can transfer too much stess to the Rear Bottom Plate in a big hit. Therefore, some drivers are using the #3340 - Low Profile Motor Pod (Right Side) on both sides of the Gen-X 10 to stiffen the rear pod.

Bill