Originally Posted by Divey

Got my build done today. Body still needs painting but other than that it's all ready to go. Handles like it's on rails. I have to get used to it compared to my truggies. Setup:
MMP/1800kv 1512
Tekno V3 kit
775 for the diffs
45wt front shock fluid
40wt rear shock fluid
Prolien Caliber
geared 18/46
HPI SF-32TT servo (same as the hitech 7955tg)

Runs good but a little slow on 4 cell lipo. Speed calculator estimates it at 37mph. On 5s it runs good with good speed. The motor would run more efficient of 5s but I wanted to run 4s because of the weight. Would it be better to gear up to a 20t pinion or keep it the same. It will be mostly ran on 4s unless I run out of all those then 5s.
Also what color scheme should I do for the body. Those are some Parma decals on there.
Thanks for looking,
Terry
Also one more thing, the front DE skid plate, does it mount the square end towards the front or rear?