Originally Posted by ddd2k

I had the same problem before so I end up using xray C-hub and steering block which I also converted to xray ECS to eliminate the chatter. The car width is the same.

here's some pics

Originally Posted by kschu

ur outer arm pin still remain the same ?

Originally Posted by pcar951

+1 ?? did you drill the arms or sleeve the pins? Looks great!

Originally Posted by ddd2k

I drilled it to have a better play...I think the yokomo pins are 2mm only, also the xray ECS uses C plastic blades for the outdrives, I run mod with the yokomo so the steel outdrives doesn't last long. The spool is by TOP and the outdrives is by someone that makes it here in the US which I found it on this forum also. This car has a lot of corner speed and I like so much than my Xray T3 2011 in terms of handling.

Originally Posted by masterhit

Awesome info, thank you very much for putting that up. Does it matter which length of X-Ray ECS's are used?

Thanks!

Mike Slaughter

Originally Posted by ddd2k

Both 52 and 50mm will fit but I can feel when the car bottoms down the 52 seems has some resistance on corners...the 50mm is the perfect fit.