Originally Posted by
defcone
There fixed it for you, so you mean if you run mod or high load motors, need to be careful not to dump your lipos as the voltage cut off doesn't work as well for high load situations?
it seem that the Cutoff (no matter you are using The Stock Firmware)
is Designed for Mod/High Load for safety reason.
but this had negative effect when using Stock/Low Load.
we found setting cutoff custom 6.7v = "lipo end3.3v/cell(Mod)" = "lipo end3.15v/cell(Stock)".
depend on Cutoff performance, this also had bad effect when Lipo already
reach near the Cutoff and Kicked with Turbo.