R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 03-13-2011 | 11:36 PM
  #2022  
TheBeavertonKid
Tech Regular
iTrader: (17)
 
Joined: Feb 2011
Posts: 299
From: Murfreesboro, TN
Default
Originally Posted by FantomLeopard
Ah, okay. I thought everyone was talking about sanding the diff rings. So just the two small washers that the 6 thrust balls go in between? Am I supposed to sand them to make them thinner or are they just not even and flat?
I was thinking to make them a little more "rough" so they grab better?
TheBeavertonKid is offline  
Reply