Originally Posted by
justicepool
Hello,
I was installed a brand new Savox 1257 in with a MMP esc and Futaba 2PL TX/RX and when I power everything on, the Savox jumps around on its own and is not responsive. I put a used Savox 1258 that I had in and it did the same thing. Plugged in a JR9000s and it was fine.
Any suggestions?
Thanks,
John
The savox servos draw a lot of volts and are causing your receiver to lose power. If you have the castle link, go into the advanced settings and change the BEC power to 6.0v (its set at 5.5 stock). I have a spektrum radio and run the spektrum capacitor (like $6). It has basically solved my problems but every once and a while I get a glitch. I;m thinking about purchasing a Castle Creations BEC, I hear that it solves the problem completely