Having run Xerun 60A controller and GM 21.5 motor the last two meetings, have ran a new Extreme Stock controller and Hobbywing 21.5 motor for the first time today at club.
Using the 211 software, started out with:-
DDRS - 9
Boost - 60
Turbo - 0
FDR - 4.78
The car was very slow with no acceleration at all, it just crawled around at just one steady speed. So note to self was these settings simply do not work!
By incremental steps I eventually ended up with:-
DDRS - 9
Boost - 36
Turbo - 24
Delay - 0.3
Timing Acc - 350
FDR - 5.1
Car was so much better and with 14.1 sec best lap time managed to shave off nearly a second per lap with this set up. from earlier times
Might need to drop the FDR to around 5.2 and the start RPM down to 300 from 4000, just to get a bit of extra speed down the staight a little earlier, but other than that the settings were not far off spot on.