I started the design / fab process in Sept 2010, I hand built my tvp's, engine plate, servo mounts and mid tank setup. Working on handcrafting my skid plate.

Parts I've used so far.
GH Steering Assembly, RPM Upper arms, HPI BP diffs, HPI XL running gear. 3spd Tranny (for the low first gear), CEN Batt Box, Mugen fuel tank, Integy HD rear hub carriers, Integy HD Hubs and Knuckles, HPI 24mm Hex adapter, Proline Desperado Beadlocks, Hostile Nightmare MX Tires, Hostile Molded Zero growth Foams, Hitec 7955TG for steering. IRC LST2 Mounts, LST2 Shocks, Raven Dual rate Springs.

The Power Plant.
ERCM Extreme modded LRP Zr30 Spec2, ERCM Endbleed pipe. Going to use a motosaver filter and XL Manifold (slightly modified)

Parts on Order / Waiting to be used
BashCat RC Braces, ERCM Equipment, Proline F650 Body, Thunder tiger turn buckles, 85067 to be used for steering rods. Hitec 5985MG for T/B, 8ft nylon Rod for A Roll cage (will fit under F650 shell)

Parts that break will be replaced with something else. lol
I know I'm forgetting stuff.
So far the truck is around 21Lb's. The No Limit RC Rules state that the Unlimited Pulling class must be a Minimum of 20.1Lbs.

**appearently I dont have enough posts to link to photos, so you cant see the images yet. But one day. I would link you to a site that has the images but I cant because I dont have enough posts. So, therin again, you dont get to see them yet**