Originally Posted by J-PaP

Hi need some advice on the best way to lower motor temps via the settings on my gt 2.1 pro stock esc while maintaining performance as much as possible. My motor after a 5.5 minute run is sitting at about 80-82c which I'm assuming is too hot. Races go for 6 minutes where I run.

Running an epic d3 21.5 roar spec on a xray t3 '11. 4.2 drive ratio.


These are my settings at the moment (running V1.35-101212stock)

1:1
2:3
3:5
4:7
5:4
6:1
7:1
8:1
9:6
10:1
11:-
12:6 (Initially used this on 7 but the car showed 80-82 degrees and faded a little. On 6 the car didn't fade at all but temps stayed the same.)
13:1
14:3
15:5 (I'm going to test dropping this to 6 next as I assume this is most likely to drop temps?)