Originally Posted by
Shawn68z
Didnt think that would slip past you, you are correct. However, I have run 75 degrees on a motor, and it slowed the motor down, and created alot of heat. I left the Novak at N (30) and ran the 46deg from the 1224 software, motor was dead slow, and created alot of heat. I should have probably run the overheat protection.. Oh well.
Shawn.
you run 75 Degrees is in incorrect way,
The V3.0_110119
is really 60°
The new firmware 110211 (213)_STOCK
64° is a different method.