any of u guys experience this with 119 firmware?
i flashed my Xerun120A V2.0 with 119 firmware (did it twice as suggested here) and configured the settings to my preferences. after which i calibrated my Tx and ESC.
i noticed that when i run the car right after callibration, i sometimes would loose initial punch. the motor punch right after you pull the throttle would be significantly lower... turbo would later kick-in as u can really hear the motor screams but initial motor punch is really missing.
i believe its DRRS setting has been lost during calibration, coz when i reprogram the ESC with the LCD programmer by just setting the DRRS to my preferred value (DRRS = 8), the initial punch returns...
just want ur thoughts or have you experience this on your set-ups?