R/C Tech Forums - View Single Post - 1/12 forum
Thread: 1/12 forum
View Single Post
Old 03-01-2011 | 08:49 PM
  #35554  
SNIPR's Avatar
SNIPR
Tech Fanatic
iTrader: (12)
 
Joined: Oct 2009
Posts: 857
From: TX
Default
Ok so I am using the Xerun 120a 1s & Trinity Duo3 10.5 in a 1/12 pan car. The track is carpet and a short track at that. Should I use the stock settings:

V3.0_110119STOCK
Initial Brake 0%
Neutral Range 6%
Boost Timing 32
Turbo Open 18
Over heat Enable
Turbo Timing 24
Boost start 4000
Turbo Delay .3sec
Boost Timing 350

1) What should I change or just leave it as is?

I also heard about using V3.0_101224STOCK Firmware w/ an LRP x12 or use the V3.0_110119STOCK w/ a less strong rotor magnetic.

Does anyone know which I should use w/ my Trinity Duo3?
SNIPR is offline  
Reply