Ok so I am using the Xerun 120a 1s & Trinity Duo3 10.5 in a 1/12 pan car. The track is carpet and a short track at that. Should I use the stock settings:
V3.0_110119STOCK
Initial Brake 0%
Neutral Range 6%
Boost Timing 32
Turbo Open 18
Over heat Enable
Turbo Timing 24
Boost start 4000
Turbo Delay .3sec
Boost Timing 350
1) What should I change or just leave it as is?
I also heard about using V3.0_101224STOCK Firmware w/ an LRP x12 or use the V3.0_110119STOCK w/ a less strong rotor magnetic.
Does anyone know which I should use w/ my Trinity Duo3?