Originally Posted by
jmpn02
Just got my B5 and a 2013 pipe from A-main. Can not wait till it gets warm enough to start the break in.
When looking at the pipe the pressure nipple seems like it is 180 degrees from the stinger so it will put it on the side of the pipe instead of at the top if the stinger is at a 90 degree position. Is this normal for a werks pipe?
When everything is together and installed it will be slightly in-board instead of directly on the top. Keeps the body from rubbing against the pressure nipple which will mess up your paint/wear a hole in it and also keeps it off the pressure line which can damage it.