I just got an Orion Twin charger and had a couple of questions. First why is it that setting 2s LiPo doesn't allow a discharge rate above 8.3a? 1s of the same or even less mah rating allows me to set a discharge rate up to the max of 10a. Also I noticed while charging or discharging the amp rate will go to 0.00a for a short time...is this normal? If so what is it doing? Also I have a 220Mah RX pack to charge but the charger settings are 200Mah and 300Mah...which should I use to get a full charge?
The web site is a mess right now and wouldn't let me send an e-mail from the site.
Last edited by InspGadgt; 02-24-2011 at 01:45 PM.