Originally Posted by
matt prigmore
Last at racing I experience the esc going onto a sensorless state twice on the start grid, in practice the car was fine but when I started a racing using full throttle the car when into this mode whitch I then had to switch the car on and of and all was fine.
I have change the sensor lead, strip motor and cleaned.
One thing I have notice for some reason I'd set the volt cut off at 3.2v per cell would this have cause this to happen.
Lrp 5900 50c ten charges old and running 1224 software and Sp v3 13.5.
All opinions welcome
Thanks matt
Worth checking the motor timing hasn't slipped?? My SP V3 moved when I had a heavy impact while racing and it felt like it was running sensorless. I think I have read on here somewhere that the endbell set to 0 degrees is equivalent to retarding the timing!!
It is only the pressure of the rubber gasket inside the endbell holding the sensor board in place.
