R/C Tech Forums - View Single Post - NEW HOBBYWING STOCK SUPERCHARGED SOFTWARE
Thread: NEW HOBBYWING STOCK SUPERCHARGED SOFTWARE
View Single Post
Old 02-22-2011 | 08:06 AM
  #3289  
terryh's Avatar
terryh
Tech Regular
 
Joined: Nov 2005
Posts: 343
Default
Originally Posted by matt prigmore
Last at racing I experience the esc going onto a sensorless state twice on the start grid, in practice the car was fine but when I started a racing using full throttle the car when into this mode whitch I then had to switch the car on and of and all was fine.

I have change the sensor lead, strip motor and cleaned.

One thing I have notice for some reason I'd set the volt cut off at 3.2v per cell would this have cause this to happen.
Lrp 5900 50c ten charges old and running 1224 software and Sp v3 13.5.
All opinions welcome
Thanks matt
I always set the cutoff to 3.2v and have never had any issues, even after a practice run where I put over 4800mah back in, I was out for a while
terryh is offline  
Reply