how deep are the indentations and did you put the electronics in the back behind the lipo? Are you planning to run it on asphalt when weather permits? Curious how that will work out with the CH.
With the db10rr on asphalt i needed to put in 50 grams of lead under the electronics, otherwise easier spinouts comming out of corners.
You can put a stripe of carbon or FRP in front of the lipo's and shoegoo it in place.(that way you can still remove the strip afterwards)
Tape the lipo's and the lipo's won't go anywere.
For the db10 i use an old L2 chasiss brace and shortend it so i ended up with the middle part with the screw holes. I aligned the first screw hole and placed it under the first standoff and it is a perfect fit. I tape the packs in and they don't go anywhere. This way i don't need the heavy lipo tray anymore and in a crash the lipo's stay where they were. (i tested it thoroughly
)