Originally posted by Frag
Hi guys,
I installed a brand new X12 Rody and noticed than the Low-Speed Needle was set to 5 turns 
I read on their web site that the low speed must be set initialy to 2 1/2 turn.
Some can clarify me on this. I am breaking-in the motor and want to make sure that I have the good low-needle setting.
By the way, what is your common after break-in setting with this motor?
I'm not sure about how you count turns,... maybe,.. just maybe,... you count half-turns as 1 turn (5 turns by your way of counting is exactly 2 times the 2 1/2 turns recommended by RB)
maybe I'm wrong though,... but a carb won't be set that far off from the factory