Originally Posted by Sarinexia

Thanks Ron, I appreciate the post. At least I know I'm not crazy.

I did put in the 3x10mm (all 4) and 1 4x10mm *all button heads*, but like you were saying, there is the final 4x10mm hole that is way close to the spur gear, and cannot set into the inner plate (as you were saying) - Thus, it's been left out of the mix.

I can't take the credit on the 3x10 screw idea. That was all Billy.

In either case; I did have to bore out the 2 holes that were resting over the 4mm holes in the motor casing. Why are these holes (out of curiosity) not already wide enough to compliment the 4mm screw in the Grid Plate's initial design?