XERUN-120A-1S ESC
ran this last night with the following setiings but it has loads of punch for 2 mins then goes soft but still quick
which way to go with the setup please?
Motor = GM10.5 2010 model on 47.3mmpr
Punch level 9
Neutral 6%
Boost 55
Turbo Slope 12
Turbo 5
Start RPM 3000
Turbo Delay 0.2
Timing Acc 150
3.0v cut off
You are using Turbo to gain punch?
I would choose a milder boost setting (45 instead of 55)
Set turbo higher, from 5 to 15 (total timing will be the same)
Maybe even an higher start RPM.
Turbo delay, to 0.3 or even 0.4 seconds.
This will arrange the turbo only kicking in on the back straight.
I think you lose the punch feeling because either, your draining your Lipo to early, or the motor gets to hot, so the rotor looses it's magnetism....