Originally posted by tamiyadriver
well, i had a few inquire about the diff swap, so here is a list of stuff:
Yokomo MR4TC belt car:
ZS-501 - diff joints (use the rear ones)
ZS-506 - diff rings (can use 414M/TA04 rings, i had some!)
ZS-507 - thrust set
ZS-508 - diff screw
ZS-010RT - rear liteweight shaft set- can use reg steel set part #
ZS-010RS
anyones 5x8mm bearings for the center of diff, and 3mm diff balls of your choice...
TRF415 parts
51055 - ball diff pulley
hardest part was the 6x11 adapting bearing that the larger Yoke drives required. found a Tamiya part # of 9805802, comes from the TXT-1 somewhere...
for the center, im sure there are a number of ways, but i just used another locked pulley, part #51060, and filed it and the spur holder down. whole setup worked great last weekend, and ill put up a few pix...
Cheers Tamiyadriver
This gives me something to do while my kit is being shipped out , time to go parts hunting around my local hobbie shops.
Setup sheets
Has anyone got blank setup sheets that can be downloaded and team drivers setup sheets for outdoors on tarmac so i can see what people have been running ?