Originally Posted by
builtb16a
the hex bolt to remove the clutch bell is a 5/64. once the bell comes off you can either remove the clutch shoes, or remove the complete flywheel assembly.
the black hex bolts that hold the shoe pins (4ea) into the flywheel is a 1/16th.
the black nut (1ea) that holds the flywheel on the collet is a 8MM.
Thanks a lot!
I found a 5/64, but no luck on the 1/16th...
As I have never used Metric, ca you tell me what are the hex I should have? In metric I am always using 2.0; 2.5; 3.0mm.
Is there a "trinity" of Imperial I should get?
I have been born and raised in Europe, and the imperial system seems so complicated LOL