Originally Posted by
rcfiend
I just purchased a the RS 17.5 combo and ran it for the first time yesterday. I have a couple of problems.
1. When I installed the software for the hotwire I get ver. 178, 180. When I try to update it says no updates available. But when I go to the website to get the 218 ver. It will not install, I get an error message and the install cancels. Oh and I'm using Win XP
2. When I ran the car it was extremely slow tried a 3.81 and 3.75 fdr. Also whatever I did I could not setup brakes for the esc. Tried resetting the speedo and same thing.
Any suggestions would be helpful.
Remove the old installation first.
Than install the new software.
After updating reset the speedo and recalibrate it with the radio.
After that put a setup on it. With a 17,5 boosted class use the sensord mode.