1/8 tyre truer adapter.
I have recently purchased the 3racing automatic tyre truer together with the adaptor to enable me to fit 1/8 wheels. I can't seem to get the adaptor to tighten to a sufficient level in order to stop it spinning on the truers shaft, if I tighten it anymore the bolt is going to sheer. The adaptor is made by 3racing so should work ok. The 1/10 scale adaptor that came with the truer works fine.
Does anyone know if the Hudy adaptor will fit as I'm not going to waste my time trying to get a replacment from 3racing as it was only $13.
Thanks.