Little setup help
Guys wondering if someone can help with some aceleration advise. I had a test day yesterday. The track slightly open, infield slightly technical because you really need to hit the right line to carry the speed over from one corner to another, but with very low grip.
The settings I orginally ran with were - P.S. Motor is Nocak Ballsitic with 0 added motor timing. (Ballistics come with +30 added timing from factory)
fdr 4.5
#9 40
#10 18
#12 20
#13 3000
#14 0.2
#15 200
Motor Temps after 10mins 74C
Eval'
Although I was running on 36 and should have been 32 and the track was dirty I was running about 0.5secs per lap off what is good pace for the track. Keeping in mind that the track was filthy and my setup was giving me a bit of an oversteer I wasn't too displeased with that.
I then changed the setup to this - same tires and car setup but starting to allow for the oversteer
fdr 4.5
#9 35
#10 24
#12 25
#13 2000
#14 0.2
#15 150
Motor Temps after 10mins 65C
Eval'
Laptimes were about 0.2 per second better and I could see the turbo kick in a bit more. My only complaint is the acceleration still wasn't there.
Any ideas for room to improve? Apart from the esc I can add more timing to motor (worried that the heat will be back up to 70+) or lower FDR (which will give me more speed overall but not sure how that will improe the acceleration issue)