Originally Posted by
Troubles Dad
rebind the radio to the receiver as per the instruction manual, keep the servos straight if possible, neutral position or if all fails unplug the servos from the receiver when binding, sounds to me that the fail safe is acting up and over taxing the servos when it loses signal
when your done binding the radio and have the receiver turned on, shut off the radio to see what exactly the servos will do when the signal is lost, hope it helps
make sure the car is not running either electric or nitro when doing this
Thanks for the suggestion.
Unfortunately, it won't bind. With bind plug in bind port, and power going to the aux port, I get nothing. The transmitter LED is supposed to blink after holding the bind button...nothin. Also, the reciever LED does not light up.
Its an SR300 receiver if that helps.
I'm thinking both the servo and receiver that came with the Spektrum DX3E have gone bad.
Do I have to get the same model receiver or can I get a better one and bind it to my transmitter?
Did I buy a crappy radio?