Originally Posted by
sizheng
Hi, ed. you come here also. I'm salton.
how about go to HANGZHOU to race this weekend?
Hi Salton, thought it was you, I've been keeping an eye on this thread recently. Can't make it to Hangzhou this weekend. Saturday I'm off to test motors at TRS, and Sunday need to go to work
And I'm also having to spend the new year in Japan on work too...
Originally Posted by
sizheng
you can get your speed by the following (assume diameter of rubber tyre 60MM).
car speed(km/h) =0.01131*RPM(MOTOR)/FDR
so please think of the speed of your car on the track, and then it may help you to set your ESC better.
Regarding this, I've attached an excel spreadsheet to help figure this out (albeit in mph). Just need to put in the internal ratio of your car, the gear ratio, tyre diameter and the speedo settings, and it calculates the speed for the start and end of the boost phase. I made it up originally to get a better understanding of the mamba cheat timing, and I've made some alterations to suit the HW software (as the end rpm is set differently on the mamba).
Originally Posted by
chinaman
wah!hey! peeps from the far south east peninsula! good to know there are those from the home country here as well ...
What about a brit based in china?
