Originally posted by Devil666
Just assembled the front portion of my 710, and noticed that the front ball diff is slightly loose...i can move it about 1mm side to side. Tried adjusting everything again, but still the same.
I had this problem in the rear and someone noticed this for me when I was in Thailand !
Did you check if the bearing and the eccentric cam were put in place properly? Left is for left and right for right side? I got mine mixed up (left to right and right to left) and that made the ball diff in the rear move sideways. Check that first.
Originally posted by Devil666
And also, when i spin the mid pulley, the belt on the front ball diff pulley looks like its gonna fall off the side, its sitting too near the edge. Is this normal?
Yes, the front belt is very near the edge of the front diff pulley. But as the front diff should not move from side to side, it should be ok.