Originally Posted by Lilhill

Just updated my speedo software to 101212STOCK and is a little unsecure of how to setup everything, how is motor temp on 1212 compared to 528??

With 528STOCK I ran my SP Ver. 3 17,5 motor and FDR 4.3 on a large indoor carpet track, motor timing was standard (In the middle, 5 degrees I guess). And ofcourse 7.4v LiPo in my 1/10 TC.

With this setup I ran every speedo setting maxed out and the motor was about 85degrees celsius after 5min heat so OK.

Do I have to change motor timing to 10degrees? I would like some advice because if I do this, the FDR should be different also.

With the setup I ran I needed more punch out of corners, but laps were faster with FDR 4.3. The new 101212STOCK software might solve this, with lower SC boost RPM right?