Originally Posted by
VooDooPH
you need to shim off the side to side play from the diff. 10mm internal diameter shims should help you do this.
for the gears, the stock ones are white... the hopup/upgrades are black.
It's not the side to side play I'm talking about, the diameter of the plastic outdrives are a bit too small for the inner diameter of the large bearings (at least on my kit). I wrapped a bit of tape around the outdrives to take up the slack and 1mm shims on both sides, now its a bit better.
Also the kit 26T pinion doesn't seem to grab on to the shafts of silver can motors, as close as I can position the pinion to the motor, at most only half of the grub screw is on the flat part of the shaft, and the pinion wobbles around. (When I flip the gear over on the shaft it spins true)
Any of you guys have this problem?
Thanks
** My 64p gears fit fine, which I'll be using anyways so I guess it doesn't matter much, just though they should fit from the kit