I'm converting my Lois Eight to electric. I decided to run a clutch setup with a servo for mechanical brakes. I have a Mamba Monster w/2650 motor. My current radio has no mixxing ability, so I just picked up a y harness and connected up the brake servo into the throttle circuit as described in Tekno's info in the conversion chassis kit. The problem is this: the brake servo operates backwards - pushing on the brakes as the throttle goes up. I tried to reverse the connector and that causes the ESC to go into and error mode where it beeps and stops functioning. Same error if you try messing around with reversing throttle at the radio.
Before I cut the y harness and start swapping wires around there, I figured I'd ask here to see if anyone has an easy answer.