Originally Posted by
SMcD
I have a question.
Well, first, I can not get my Kinetic to upgrade to 1.4 firmware.
So assuming, I'm stuck with 1.3, WHY when I set timing to anything less than 20
does the boost option automatically turn to the 'off' position? Effectively making it impossible for me to run boost at anything less than 20 degrees timing? I use the 2s 13.5 option in the drop down box. Thanks.
I sent an email to novak CS about getting an upgraded brain board with 1.4 but no response yet
Thanks.
boost only works when using more than 20 degrees of timing. All boost is is 50+ degrees of timing hitting at once. It's easier to drive if you have a lot of timing added spread over a wide rpm range instead of using boost.