R/C Tech Forums - View Single Post - Using old servo control boards as actuator driver/motor ESC for PROPORTIONAL control
Old 01-21-2011, 12:28 PM
  #9  
EQMOD
Tech Regular
iTrader: (1)
 
Join Date: Jul 2010
Posts: 338
Trader Rating: 1 (100%+)
Default

Here is a new one - Small Kart racer with the proportional control steering and throttle.



Specs:

1. 1S Lipo Power
2. 2.4Ghz Efly RX/TX combo
3. 2 Servo Control boards - one for steering and another one for throttling.
4. a couple of centering pots (5kohm)



Using the bulky TX with the programmable TX parameters



With the onboard electronics;



Electronics neatly attached;



Gas time (Lipo charger)



VIDEOS:

Proportional Control Actuator and Steering in action

+ YouTube Video
ERROR: If you can see this, then YouTube is down or you don't have Flash installed.


Table Top:

+ YouTube Video
ERROR: If you can see this, then YouTube is down or you don't have Flash installed.


Floor:

+ YouTube Video
ERROR: If you can see this, then YouTube is down or you don't have Flash installed.
EQMOD is offline