Originally Posted by
racerdork
Did you put the controle horn on while you had the servo on and trimed?. Also if you are using a tamiya esc then you need to set it. First press the red set button on the esc the red light should sart flashing. Press it again this will set the nutral trigger position next pull the trigger all the way down and press the red buton again, last push the trigger all the ay down on full brake/reverse and push the red button and the esc should be set. this should be the same as the intructions.So go grab the bag the esc came in and read the info. hope this helps
What do you mean by control horn? sorry i'm really new to this. Yeah I did set up the ESC with the transmitter. Before setup the whole car just goes haywire (rapidly turning left and right on its own and car just goes back and forth without pressing anything on the transmitter.) After setup, the throttle is fine but steering is just always to the left and if I steer to the left even, it just makes the car go forward. I'm thinking it may very well be what gt says that I need 35A.