Hi, I'm fairly new with R/C's. I just bought a new ezrun 9t brushless motor with ezrun 60A ESC. I installed it to my Tamiya with the ESC in the ch2 of my receiver. I was able to setup my transmitter with the ESC by following the instructions on the manual. My problem is that when now when I turn on the RC, the wheels would go all the way to the left, even when i trim the transmitter all the way to the right, the wheels are still towards the left a little bit. The Throttle is fine, it goes forward, brake and reverse. Another problem I have is when I steer the transmitter to the left, the car would move forward even when I have the throttle on neutral. I'm out of ideas. Please help.