R/C Tech Forums - View Single Post - CRC 1/10 Pan Car
View Single Post
Old 01-19-2011, 08:43 PM
  #1468  
Still Bill
Tech Champion
iTrader: (16)
 
Join Date: Jan 2004
Posts: 7,379
Trader Rating: 16 (100%+)
Default

Originally Posted by JR007
I'd LOVE to get out there testing. Get the violins out for this bit. I have a wife and kids, full time job, and am 30 minutes from the track, so i'm lucky to get one practice session between our monthly meets.

I do have 2 sets of front ends, so I may set them up identical except for the axle and then it will be a quick swap. Although, for now Ii'm probably better off getting my consistency better, then start tweaking stuff like that.

On the plus side, I raced last weekend with a couple of other guys at a new track, and my car was the only one that didn't look like it was racing on ice. Was nice to be the guy with the money set-up for a change!
Your track at www.crccc.co.nz is a monster layout. I would have trouble just "seeing" the track.

Are you running the 235mm wide configuration with a CanAm body?
Still Bill is offline