Hey people,

got a strange thing with my software....

I upgraded the esc and 2 in 1 box with the new 1224 software,
that all went ok. Then i try to change the timing settings to my own choice.
Standard the boost setting is 22 and the turbo 14,

When i try to change this to lets say:
boost 19 and turbo 12 all works out as it should have when i do the apply.
So everything loads in the esc.

Then i go for a drive...and after that i check the settings:
The boost and timing setting are back at the standard 22 boost and 14 turbo.
It looks like the esc doesn`t hold the settings, same for rpm ranges etc..

Tried to reload the 1224 to esc and 2 in 1 box and also back to 518 and back...
the 518 does hold its settings.

Does anybody has the same problem or knows a method to get it right...????