Originally Posted by
steveonamission
Went testing today, got a chance to run a 0 block, and it was bloody awful...
Im convinced now that less front arm sweep , gives more initial, as it was soo aggresive on initial turn, i could'nt handle it over a 5 minute run, aswell as my laptimes being slower, found it quite strange that the car reacted so much with the change, completely different animal
Went back to the 2.5 block and all was good again.
From what im finding it depends a lot on the Tyre. This weekend i raced on Nosram 30X tyres, the car was very inconsistant with the "std" setup we have been using. I tried lots and as soon as i put the 0 block on the front the car was much better to drive and way faster. I actually found teh car turned more consistantly around the corner rather than lots of initial turn, and understeer middle or out of the corner. If you use the 0 block make sure you uses 5.5mm of hex on the front.
Originally Posted by
AGNO
I use 65mm, more possibility to adjust the droop.
I wouldnt go longer than 65mm if you want to use higher ride heights as we talked about a few pages back