Originally Posted by
RCveteran
No luck yet, it's an Airtronics MX-3X which has adjustments for everything and everything.
When you say 100% on end points which specifically, I cleared all the settings to a standard default on the radio to make sure nothing I set was odd.
I read a couple old threads that say this delay may be normal while the ESC energizes and figures out where the rotor is. I have other sensorless ESC's that do not do this though or at least at a level so low I can't tell.
Default should be right on, just make sure you have completed calibration after you reset the radio.
You should not notice any delay, just like with your other sensorless controllers. I have used almost every brand available of sensored and sensorless and the EZRun should be as quick and smooth off the line as any.
Aside from setup, there are only a few other options: I see poor connections cause most problems, weak batteries, and faulty equipment are other possible causes. If you have other motors or ESCs available to test that would be a good idea to eliminate any potential problems.