R/C Tech Forums - View Single Post - Capricorn LAB-C01
Thread: Capricorn LAB-C01
View Single Post
Old 01-12-2011, 11:55 AM
  #746  
Chickentrader
Tech Elite
iTrader: (13)
 
Chickentrader's Avatar
 
Join Date: Feb 2007
Location: Landsborough, Queensland, Australia.
Posts: 2,142
Trader Rating: 13 (100%+)
Default
Originally Posted by Rawz
Yes, I think that screwing the original ones to be certain it won't come off, I will have a too short shock.

I will try the ballends from a MTX4 I have, long ones...

What I really liked about this kit is the consistency and felling. Every change I did I could tell what was going on, the car keeps giving feedback easy to "read".
I have little experience, yet, but for me it was great.

Thankx for the input guys.
Mugen uses 6mm pivot balls, while Capricorn and X-Ray use 5.8 mm balls. You'll need to change to 6mm pivot balls if you use Mugen ball ends. Mugen and X-Ray ball ends, other ball linkages and top of shockie ball mounts are also harder and won't pop off that easy.

Kindest regards,
Lars.
Chickentrader is offline  
Reply