R/C Tech Forums - View Single Post - Negatives to Boiling Plastic Parts?
View Single Post
Old 01-09-2011, 06:03 AM
  #1  
shanty140
Tech Master
iTrader: (5)
 
shanty140's Avatar
 
Join Date: Nov 2008
Posts: 1,279
Trader Rating: 5 (100%+)
Default Negatives to Boiling Plastic Parts?

I was wondering if anyone can tell me some negatives to boiling plastic parts. I am looking at boiling my arms on my MBX6T. I have never broken an arm, but if it's going to add some assurance then why not do it. I see some Pros boiling arms so I am going to assume the Positives out way the Negatives. But I don't know for sure. The only negative I can really think of is the arms may bow out a bit more over time.

Thanks
shanty140 is offline