R/C Tech Forums - View Single Post - Tekin RS ESC sensored
Thread: Tekin RS ESC sensored
View Single Post
Old 01-07-2011, 07:10 PM
  #19110  
stipres
Tech Master
iTrader: (70)
 
stipres's Avatar
 
Join Date: Jan 2005
Location: Temecula, CA
Posts: 1,079
Trader Rating: 70 (100%+)
Default
Originally Posted by syndr0me
What's it mean if the ESC can't "see" the motor (the sensor LED's don't light) and the two LED's at each end of the bar flash?
I had a motor wire come off at the solder joint. It gave the same code you are having. May want to double check...

Originally Posted by mikeygar
Randy,

I have a Tekin RS which I plan to use on my 1/12th with a 1s lipo. Does the motor turn limit still apply or can I safely use a 4.0/4.5T since I assume the ESC will be pulling less amperes? Searched but very little info on this topic.

Lastly, I can't seem to find the wiring diagram for the RS with a booster/RX pack. Do I just remove the red wire in the ESC's plug?

Thanks in advance!
We use the RX pack and it is not necessary to remove the wire. Just keep the ESC's switch in the off position.
stipres is offline  
Reply